Calibration · Published October 7, 2026 · 3 min read
Why location matters when you install a scale
This article is about force-based weighing equipment, such as many electronic scales that use load cells, before it has been compensated or adjusted for the place where it is installed.
Why location matters
Gravity varies with location. Moving some force-based weighing equipment can change its indication unless the instrument is correctly compensated or adjusted for the new location. The effect depends on the instrument, locations, and setup.
Take a scale set up in Ohio and installed in Anchorage. Anchorage is much farther north, and gravity is a little stronger at higher latitudes. Whether that move changes the reading, and by how much, depends on the instrument and how it was set up in the first place.
Geocode settings and compensation
Some instruments have a setting or a procedure for the location where they will be used. Not every model has one. Follow the manufacturer instructions for the installation location and confirm performance using the appropriate procedure.
On commercial equipment, location settings can sit behind a seal. Leave sealed settings to a technician.
When to have it checked
- New equipment arriving from a supplier outside Alaska.
- A scale or balance moved between towns or sites.
- Used equipment bought from another state.
- Commercial scales, which are held to NIST Handbook 44 as Alaska has adopted it.
In each case, testing at the final location shows whether the instrument needs adjustment. For the commercial side, see what the state expects of a commercial scale.
